The world’s first Multigigabit Ethernet switch with eight full power PoE+ and multi-speed 1G, 2.5G ports combined with two 10G uplinks for a fully non-blocking deployment of eight Wave 2 11ac access points from any vendor.
The ProSAFE® M4200-10MG-PoE+ Managed Switch was designed from the ground up to optimise the installation of Wave 2 11ac access points. Includes eight full power PoE+ and multi-speed 1G, 2.5G ports for 100 metre legacy cable runs, combined with two 10G uplinks for a fully non-blocking deployment of eight Wave 2 11ac access points. Two of these eight 1G, 2.5G PoE+ ports also support 5G speed. NETGEAR Multigigabit Ethernet is compatible with most major wireless and switching vendors managed solutions, and the only one with 8x2.5G to the AP with 240W PoE available and 2x10G line-rate aggregation to the wiring closet. Plenum rated, slim design and mounting accessories allow you to place this switch to optimise access point placement and cabling efficiency, inside and outside the rack.
1G, 2.5G and 5G NBASE-T compliant access layer in campus LAN and midsize organisations networks
Line-rate 8 x 2.5G access layer and 2 x 10G aggregation for 802.11ac wireless access points with PoE+ full provisioning
Advanced Layer 2, Layer 3 and Layer 4 feature set including static routing and RIP dynamic routing
Multi-Gigabit NBASE-T enables 2.5X to 5X faster speeds up to 100m on legacy Cat5e/Cat6 cables - yet providing 100M and 1G backward compatibility
Whisper quiet 28.9dB acoustics when operating at 25°C (77°F), well below normal offices ambient background noise
Secure placement above drop-down ceilings, in air passageways and where other switches will not go, vertical or horizontal, flat or perpendicular
Easy Mount options whether it's directly on a wall, attached to a rectangular or round pole, or mounted in a standard 19-inch rack
PoE+ (30 watts per port) across all (8) Multi-Gigabit access ports with 240W budget
Low latency and scalable table size with 16K MAC, 1K ARP/NDP, 1K VLANs, 64 routes
SDN-Ready OpenFlow 1.3 support for maximum investment protection
Standard Rack Mounting
Attaching the Switch to a Rectangular Pole using Rubber Belts
Attaching the Switch to a Round Pole with 10cm Hose Clamps
Attaching the Switch to a Wall