

Tone Generator:
Use the Ideal Networks Tone Generator to apply a tone signal to a wire pair or single conductor, and trace with an amplifier probe. When used with the amplifier probe, the tone generator allows technicians to identify a wire within a bundle, at a cross connect or at a remote end. It can be used on twisted pair, coax, and de-energised AC wiring.


Amplifier Probe:
The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the most congested cable bundles. Our unit can be used with any tone generator.
Tone Generator:
Use the Ideal Networks Tone Generator to apply a tone signal to a wire pair or single conductor, and trace with an amplifier probe. When used with the amplifier probe, the tone generator allows technicians to identify a wire within a bundle, at a cross connect or at a remote end. It can be used on twisted pair, coax, and de-energised AC wiring.


TRACETone® Tone Generator and Amplifier Probe
Features:
Test continuity and locate signal of installed wire and cable
Two selectable tone styles and adjustable volume control
Tone Generator & Amplifier Probe fit together for easy storage
RJ-11 Alligator Clip, RJ-11 Cable Assembly included


The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the most congested cable bundles. Our unit can be used with any tone generator.
Works with any Tone Generator (62-160) to identify and trace wires within a group
Volume control for increased sensitivity and adjustable to suit work environment
Recessed ON/OFF button prevents battery drain.
Battery low indicator
9 volt battery included


The LinkMaster™ Tester consists of two units. The main unit is connected to one end of the cable to be tested and the remote unit is connected to the jack at the far end of the cable (wall outlet, patch panel port, etc.)
Features:
Bright LED indicators for working in low light conditions
Instantaneous test results
Tests installed twisted pair wiring
Tests unshielded and shielded modular plugs
Test device used with UTP (Unshielded Twisted Pair) and STP (Shielded Twisted Pair) wiring.
Checks continuity and configuration of wiring with unshielded and shielded modular plugs.
Tests for open circuits, shorts, miswires, reversals, and split pairs.
Main unit and one remote allow one person testing of T568A, T568B and 10/100/1000 Base-T.
Remote has wiring chart identifying T568A and T568B wiring configurations.
Press and hold the test button to scan for detailed results of each pair.
Low battery indicator.
Compact and durable units.
Battery included.



